5-14
5.3.4 TX POWER
The “TX POWER” setting can be changed. The setting range is from 0 to 10. When "0"
is set
to “TX POWER,” transmission will be stopped. When "10" is set, the output will
be at its highest. The larger the value, the larger the transmission output, and also the
wider the search range becomes.
5.3.5 TX PULSE
The “TX PULSE” setting can be changed. The setting range is from 1 to 20. "1" is the
minimum, and "20" is the maximum. It is recommended to use a short pulse width
when you want to detect a fish school in the shallows or when you want to confirm the
density of a fish school.
5.3.6 TX SYNCRO
This is for setting the synchronization of the sonar operations. When "Internal" is set
for “TX SYNCRO,” the sonar will be operated in synchronized mode. When "External"
is set, the sonar will be operated in synchronization with external signals. If there is a
lot of echo sounder noise, etc., it is recommended to input external signals from the
echo sounder and operate the sonar in external synchronization mode.
5.3.7 TX CYCLE
The transmission cycle can be adjusted. It is recommended to increase the set value
when there is interference. This function is enabled when 5.3.6.
TX SYNCRO
is set to
"INTERNAL."
5.3.8 SONAR AREA
Using this "SONAR AREA," the sonar images to be displayed on the screen can be
changed without opening the menus of the multiple sonar area mode.
5.3.9 SUB AREA 1
5.3.10 SUB AREA 2
5.3.11 SUB AREA 3
5.3.12 SUB AREA 4
Using "SUB AREA 1
” through “SUB AREA 4," the SUB AREAs to be displayed on the
screen can be changed without opening the menus for these SUB AREAs.
Summary of Contents for SCS-60
