7-11
7.3 Manual handle operation procedure
1) Remove the wingnut that fixes the
manual handle and set the handle to
the feed screw shaft as shown in the
figure. Screw the removed wingnut into
the bolt.
2)
Please make the brakes release, which are located in the lower part of the Hoist Motor (2
spots in the drawings). Also, you need to confirm if this handle is operative manually.
3) Remove the cover of the fall stopper, and then turn the lever in the lower part.
4) Turn the manual handle and ascend/descend the hoisting system to the desired
position.
Lever
Manual handle
Descent
Ascent
Brake release screw
Brake release screw
When using the manual handle operation, please confirm to make the “SWITCH OFF.”
If it is kept switch on, this device might suddenly be operated.
!
Warning
Summary of Contents for SCS-60
