Apply a bead of low-temp hot glue in the location
shown. (fig. DD)
Step 30
Use a metal ruler to crease the foam on the
leading edge of each wing piece. Align the ruler
with the leading edge line as shown. (fig. AA)
Step 27
© 2013 SonicDad Enterprises All rights reserved
Hold the wing piece vertically on a flat surface
and gently bend the leading edge over as shown.
Carefully fold the leading edge down on all three
wing pieces. (fig. BB)
Step 28
Use the camber gauge to check the camber in all
three wing pieces. Adjust the camber to match
the gauge if necessary. (fig. CC)
Step 29
Check wing camber with
camber gauge
fig. CC
fig. DD
Apply glue here
Rev:03/15/13
Project #40 Page 11/25
FPG: Sonic Silhouette
fig. AA
Crease
foam on
leading
edge line
Carefully bend the leading
edge on flat surface
fig. BB
