Getting Started Guide 7.0 | 13
Connecting and Configuring Network Settings
This section contains the following sub-sections:
z
“Connecting the SonicWALL Email Security to Your Network” on page 13
z
“The SonicWALL Email Security Interface” on page 14
z
“Changing the Default Administrator Password” on page 14
z
“Using Quick Configuration to Set Up Email Management” on page 15
Connecting the SonicWALL Email Security to Your Network
Your SonicWALL Email Security appliance is designed to operate in most network setups with
minimal configuration. The diagrams below provide a “before” and “after” view of a network using
SonicWALL Email Security.
1. Plug one end of the provided Ethernet cable into the LAN port on the back of your SonicWALL
Email Security appliance.
2. Plug the other end of the cable into an open port on your network hub or switch.
Note:
z
Your SonicWALL Email Security Appliance will perform better if you follow the shutdown
procedures when you need to power-down. To shut down your appliance, use the web interface,
or press the power button on the front of the appliance once. Holding down the power button
or unplugging your appliance does not give it time to write all the data in volatile memory to
stable memory, and you may lose settings or data.
4
Local
Clients
Incoming
Outgoing
Incoming
Outgoing
Mail Flow Before SonicWALL Email Security
Mail Flow After SonicWALL Email Security
EMAIL SECURITY 8000
Summary of Contents for Email Security 7.0 8000
Page 23: ...22 Email Security Software...
Page 24: ...Getting Started Guide 7 0 23...
Page 31: ...30 Email Security Software...
