Page 10
SonicWALL PRO 3060 Front View
• Console Port - DB-9 RS-232 Console port for Command Line Interface support.
• Alarm - Lights when the firmware is reset and when certain network traffic conditions occur.
• Test - Lights when the SonicWALL is powered up and performing diagnostic tests to check for proper
operation. These tests take about 90 seconds. If the Test LED remains lit after this time, power down
the SonicWALL and apply power again after a few seconds.
• Power - Lights up when power is applied to the SonicWALL.
There are three available Ethernet ports: one for the LAN, one for the WAN port, and one optional port:
Note! To activate additional ports, you must upgrade to SonicOS Enhanced.
• Link - Lights up when a Twisted Pair connection is made to another Ethernet device on the port. Note
that the device connected to the SonicWALL must support the standard Link Integrity test.
• 100 - When the connection is a 100 Mbps connection, the 100 light is lit indicating a network speed of
100 Mbps.
• Activity - Lights up when the SonicWALL transmits or receives a packet through the Twisted Pair port.
Console Port
Test
Power
Alarm
LAN
link, 100, act
(X0)
WAN
link, 100, act
(X1)
Optional
Port
link, 100, act
(X2)
Purchased
Upgrade
