SMA 210/410 Deployment Guide
Additional Configuration
19
Configuring a Default Route
Refer to the following table to correctly configure your default route for the scenario you selected.
To configure a default route:
1 Navigate to the
Network > Routes
page.
2 Enter the upstream gateway device’s IPv4 address in the
Default IPv4 Gateway
field or the IPv6 address
in the
Default IPv6 Gateway
field.
3 Select
X0
as the interface and click
Accept
.
Adding a NetExtender Client Route
NetExtender allows remote clients to have seamless access to resources on your local network.
To configure a NetExtender client route:
1 Navigate to the
NetExtender > Client Routes
page.
2 To force all SMA client traffic to pass through the NetExtender tunnel, select
Enabled
from the
Tunnel All
Mode
drop-down list.
If you are using scenario:
Your upstream gateway IP address will be:
A
- SMA on a New DMZ
The IP address of the DMZ interface you create
B
- SMA on an Existing DMZ
The existing DMZ interface IP address
C
- SMA on the LAN
The LAN interface IP address
