SMA 210/410 Deployment Guide
Additional Configuration
5
18
Additional Configuration
This section describes some additional configuration settings for your SMA 210/410, depending on the
deployment scenario you selected.
Topics:
•
•
Adding a NetExtender Client Route
•
Setting Your NetExtender Address Range
•
Configuring the X0 IP Address
When deploying the SMA in any of the scenarios mentioned in
Selecting a Deployment Scenario
, you
need to reset the IP address of the X0 interface on the SMA to an address within the range of the new or existing
DMZ or the existing LAN subnet.
To configure the X0 IP address:
1 Connect your computer to X0 and log into the SMA appliance by navigating to
on your Web browser.
2 Navigate to the
Network > Interfaces
page.
3 In the Interfaces table, click the Configure icon for the X0 interface.
4 In the Interface Settings dialog box, set the
IP Address
to an unused address within your DMZ or LAN
subnet.
5 For the
Subnet Mask
, enter the value that matches your DMZ or LAN subnet mask, such as
255.255.255.0.
6 Click
Accept
. A warning displays that you are changing the X0 IP Address. Click
OK
to acknowledge.
7 Reset the management computer to have a static IP address in the range you just set for the X0 interface.
For example, if you set X0 to 10.1.1.10, you could set your computer to 10.1.1.20.
8 Log into the SMA management interface again, using the IP address you just configured for the X0
interface. For example, point your browser to
TIP:
For additional information, see the
SMA 210/410 Quick Start Guide
.
