Network Page 61
Configuring WAN Probe Settings
The SonicWALL sends probes to a target IP address of an “always available” target upstream device on
the network, such as an ISP side router, to monitor connectivity.
To configure WAN Probe Settings:
1.
Select Ping (ICMP) or TCP from the Probe Target menu.
2.
Enter the IP address of the target device in the IP Address field.
3.
If you have another target device, enter the IP address in the Optional Probe Target field and select
AND or OR from the menu.
4.
If necessary, configure the Secondary WAN Probe Settings in the same manner as the Primary
WAN Probe Settings.
5.
Click OK.
Note:
If the Probe Target is unable to contact the target device, the interface is deactivated and traffic is no
longer sent to the primary WAN.
WAN Load Balancing Statistics
The WAN Load Balancing Statistics table displays the following WAN Interface statistics for the
SonicWALL:
•
Link Status
•
Load Balancing State
•
Probe Monitoring
•
New Connections
•
Total Connections
•
Rx Unicast Packets
•
Rx Bytes
•
Tx Unicast Packets
•
Tx Bytes
•
Tx Current Percentage
•
Tx Current Throughput (KB/s)
Click the Clear Statistic button on the top right of the Network>WAN Failover & Load Balancing page
to clear information from the WAN Load Balancing Statistics table.
Outbound Load Balancing Method
By default, Basic Active/Passive Failover is selected with Preempt and failback to Primary WAN
when possible selected. Basic Active Failover only sends traffic through the secondary WAN when the
Summary of Contents for SonicOS Enhanced 2.2
