background image

 

Information Specific authorization of 

APL22-06F / TZ 200 and APL22-07F / TZ 100 

 
NOTE: This equipment was tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 
generates, uses, and can radiate radio frequency energy. And, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If 
the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try and correct the interference using one or more of the following measures: 
 - Reorient or relocate the receiving antenna. 
 - Increase the separation between the equipment and the receiver. 
 - Connect the equipment into an outlet on a circuit different from the receiver connection. 
 - Consult SonicWALL for assistance. 

 

 

This Class B digital apparatus complies with Canadian ICES-003. 

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. 

 

 

Complies with EN55022 Class B and CISPR22 Class B. 

 
 

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this 

equipment. 

 
 

EU Declaration of Conformity 

Application of council Directive 2004/108/EC (EMC) and 2006/95/EC (LVD) 

 

Standards to which conformity is declared 

EN 55022 (2006) +A1 (2007) Class B 

EN 55024 (1998) +A2(2003) 

EN 61000-3-2 (2006) 

EN 61000-3-3 (1995) +A2 (2005) 

EN 60950-1 (2006) 

 

National Deviations: AT, AU, BE, CH, CN, CZ, DE, DK, FI, FR, GB, GR, 

HU, IE, IL, IN, IT, JP, KR, NL, NO, PL, SE, SG, SI 

 

***Signed by John Gmuender, June1 2009 

  

 

 

 

All products with country code “” (blank) and “A” and “J” are made in the USA. 

All products with country code “B” are made in China. 

All products with country code “C” or “D” are made in Taiwan R.O.C

 

 

 

 

SWL-APL22-06F and SWL22-07F 

Summary of Contents for TZ 100 Series







Reviews: