Page 26
SonicWALL TZ 170 Security Appliance Regulatory Statement
and Safety Instructions
Regulatory Model/Type
Product Name
APL11-029 and APL14-033
SonicWALL TZ 170
Note:
Detailed regulatory information can be found in the electronic file,
“SonicWALL_Products_Regulatory_Statement.pdf,” located on the SonicWALL
Resource CD provided with the unit.
Power Supply Information Models APL11-029 and APL14-033
If you need to order a power supply for your SonicWALL TZ 170, contact SonicWALL
Technical Support at 408-752-7819 for a replacement.
This product should only be used with a UL listed power supply marked “Class 2” or
“LPS”, with an output rated 5 VDC, minimum 2.4 A.
Considerations for Mounting the APL11-029 and APL14-033
•
Consideration must be given to the connection of the equipment to the supply circuit
and the effect of overloading the circuits has minimal impact on overcurrent
protection and supply wiring. Appropriate consideration of equipment nameplate
ratings must be used when addressing this concern.
•
A power cord is included only with units shipped to North America.
•
Mount in a location away from direct sunlight and sources of heat. A maximum
ambient temperature of 104º F (40º C) is recommended.
•
Route cables away from power lines, fluorescent lighting fixtures, and sources of
noise such as radios, transmitters, and broadband amplifiers.
•
Ensure that no water or excessive moisture can enter the unit.
•
Allow unrestricted airflow around the unit and through the vents on the side of the
unit. A minimum of 1 inch (25.44mm) clearance is recommended.
Lithium Battery Warning
The Lithium Battery used in the SonicWALL security appliance may not be replaced by
the user. Return the SonicWALL security appliance to a SonicWALL-authorized service
center for replacement with the same or equivalent type recommended by the
manufacturer. If, for any reason, the battery or SonicWALL security appliance must be
disposed of, do so following the battery manufacturer's instructions.
