System settings
46
Adjusting the metronome volume
① Press
METRO
, and select MTRO.
② Turn the
VALUE knob to adjust the metronome
volume.
• The metronome volume is shown on the display.
• The adjustment range is 0–15.
Enabling/disabling speaker output
① Press
, and select MUTE or SPK.
Setting the headphone gain
① Press
, and select the gain.
• The headphone gain is shown on the display.
• Three types of volume ranges can be selected.
1.
LOUD
2.
NORM
3.
SOFT
• Set this correctly to prevent damage to the head-
phones or external device being used.
Restoring to factory default settings
(factory reset)
① While pressing
, press and hold the POWER
switch.
• The LIVEN BASS&BEATS will start up, and F.RST
will appear on the display.
② Press
.
• After resetting completes, OK will appear on the
display.
• Press
to cancel.
• This will not restore wavetable data to the factory
default. To restore the wavetable data, download it
from the SONICWARE website and import it.
4.
LINE IN (LN.IN on display): Use clock from LINE
IN.
Setting SYNC IN polarity
① Press
CLOCK
, and select S.I.PO.
② Turn the
VALUE
knob to set the polarity.
• The polarity is shown on the display.
• Two types of polarity can be selected.
1.
FALL: Synchronizes with the falling of the sync
signal.
2.
RISE: Synchronizes with the rising of the sync
signal.
Setting SYNC OUT polarity
① Press
CLOCK
, and select S.O.PO.
② Turn the
VALUE knob to set the polarity.
• The polarity is shown on the display.
• Two types of polarity can be selected.
1.
FALL: Synchronizes with the falling of the sync
signal.
2.
RISE: Synchronizes with the rising of the sync
signal.
Setting knob movement behavior
① Press
SYSTEM
, and select KNOB.
② Turn the
VALUE knob to select the knob behavior.
• The behavior type is shown on the display.
• Two types of knob movement behavior can be se-
lected.
1.
JUMP: When a knob is moved, the parameter
changes immediately.
2.
LATCH (LTCH on display): The knob does not af-
fect the parameter value until its position reach-
es that value. Then, the value follows the knob.
• When in latch mode, the movement of the dots on
the display show the direction of the current pa-
rameter value. (If the parameter value is lower than
the knob setting, they light to appear to be flowing
left. If the value is higher, they appear to be flowing
right. The farther away the value is, the faster they
flow.)
