System settings
45
This section explains settings related to the system.
Explanations assume that the function setting state has
been enabled.
Press and hold
to enable the function setting state.
(Exceptions are checking the system version, conducting
a factory reset, and updating the firmware.)
Setting the automatic power off function
① Press
SYSTEM
and select A.PWR.
② Turn the
VALUE
knob to select the automatic
power off setting.
• Automatic power off has four settings.
1.
OFF: Automatic power off is disabled.
2.
30 minutes (0.5H on display): Power will turn off
automatically after 30 minutes without operation.
3.
1 hour (1H on display): Power will turn off auto-
matically after 1 hour without operation.
4.
3 hours (3H on display): Power will turn off auto-
matically after 3 hours without operation.
5.
6 hours (6H on display): Power will turn off auto-
matically after 6 hours without operation.
• Unsaved data will be cleared when the power turns
off automatically. Always save data that is needed.
Setting the battery type
① Press
SYSTEM
, and select BATT.
② Turn the
VALUE
knob to select the type of bat-
tery.
• 3 types of batteries can be selected.
1.
Alkaline (ALKL on display)
2.
Nickel-metal hydride (NIMH on display)
3.
Lithium (LTHM on display)
• The remaining charge shown could be higher than
the actual amount depending on the type of re-
chargeable battery.
• Please set this correctly because it effects opera-
tion time.
Setting the master tuning
① Press
SYSTEM
, and select TUNE.
② Turn the
VALUE
knob to set the master tuning.
• The master tuning setting (in cents) will be shown
on the display.
• The adjustment range is − 75 – +75.
Checking the system versions
① While pressing
, press and hold the POWER
switch.
• The LIVEN BASS&BEATS will start up, and VER. will
appear on the display.
② Press
to select the system version.
• The system version (S M.m) is shown on the display
(M: major version, m: minor version).
• Press
to show the boot version (BM.m on dis-
play). Press
to show the preset version (PM.
m on display).
• Press the same page button again to show the
build number.
• Press
to start up normally.
Outputting bass and drums separately to
left (L) and right (R) channels
① Press
SYSTEM
, and select SPLT.
② Turn the
VALUE
knob, and select ON.
• The bass will be output on the L channel and the
drums will be output on the R channel.
Setting the clock source
① Press
CLOCK
, and select SRC.
② Turn the
VALUE knob to set the clock source.
• The clock source is shown on the display.
• Four types of clock sources can be selected.
1.
IN T E R N A L ( I N T o n d i s p l a y ) : U s e L I V E N
BASS&BEATS internal clock.
2.
MIDI: Use MIDI clock.
3.
SYNC: Use SYNC IN clock.
