9. Serial Control Interface
Deactivate all microphones
“%V00000116F\r”
“%” is the start of transmit character (0x25)
“V” indicates command type
“0000” indicates no mics active
“0116” is the 16 bit CRC
“\r” is the end of transmit character (0x0D)
System reset (deactivate all microphones)
“%R0052\r”
“%” is the start of transmit character (0x25)
“R” indicates command type
“0052” is the 16 bit CRC
“\r” is the end of transmit character (0x0D)
AMX/Crestron Interface
The AMX/Crestron interface provides simple record control
and monitoring for the AMX/Crestron range of Control
Panels. These control panels provide a flexible user
interface that can be used in addition to the client PCs
running Net-Log-Win.
There are no additional configuration options for this
interface type. The COM port settings and the protocol
commands are fixed.
AMX/Crestron Protocol
The serial settings on Net-Log for the AMX/Crestron
interface are as follows:
Serial port:
COM2
Baud rate:
19200
Data bits:
8
Stop bits:
1
Parity:
none
Flow control:
none
The Net-Log recognises 5 serial commands issued by the
AMX/Crestron Control Panel. These commands share a
common structure as shown:
CMD DATA NL CR
where:
CMD is the command identifier
DATA is the data associated with the command
NL is the new line character (0x0A)
CR is the carriage return character (0x0D)
The Net-Log issues a reply to all valid commands received.
The type of reply depends on the type of command
received. For non-data request commands, the reply will
either be an acknowledgement or an error code. For data
request commands, the reply will consist of the data
requested.
Record Start Command
Command: “START:ch\n\r”
Reply:
“ACK\n\r” or “ERR:ee\n\r”
where: START: = command identifier
ch = channel 1,3 for stereo or 1,2,3,4 for mono
\n\r = new line(0x0A) and carriage return(0x0D)
ACK = command accepted
ERR: = command rejected
ee = error code (see below for error codes)
Sonifex Net-Log-Win User Handbook
28
Summary of Contents for Net-Log
