© 2018 Sonim Technologies Inc. All Rights Reserved.
1825 S. Grant Street Suite 200, San Mateo, CA 94402- USA
Tel : +1.650.378.8100 Fax : +1.650.378.8109
Does Sonim XPand Direct Mode accessory and application create a mesh network
?
No, the current version of the accessory does not support mesh networking.
Is the antenna on the XPand Direct Mode accessory removable?
Yes, it is a standard SMA connector, and easy to replace. Please visit sonimtech.com or store.sonimtech.com for
replacement antenna option.
Are the screws on the XPand Direct Mode accessory retaining and replaceable?
Yes, the screws retain in the access ory, however they are easy to replace. Please visit sonimtech.com or
store.sonimtech.com for replacement screws.
Are my existing Bluetooth or wired accessories compatible with XPand Direct Mode and app?
Audio is routed through the XP5s or XP8 handset, or connected and compatible accessories.
What is the warranty of the XPand Direct Mode accessory?
One year limited liability warranty. Please reach out to
support@sonimtech.com
for warranty support.
Is the XPand Direct Mode non-incendive C1D2 like the XP5s and XP8 handsets?
No, the XPand Direct Mode accessory is not non-incendive C1D2.
Do you provide a software development kit (“SDK”) for application developers?
Yes, Sonim SDK is available at www.sonimtech.allbound.com.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) thi s device must accept any interfer ence rec eived, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by tur ning the equipment off and
on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance cou ld void the user's
authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the U.S. Government.
