1. System includes one main speaker and one auxiliary speaker.
2. Instruction manual (this booklet).
3. Warranty Card
2
1
4
3
5
9
6
8
7
1.Auxiliary speaker
2.Main speaker
3.Power indicator light
4.Power switch
5.Volume control
6.Signal input wire
7.DC input wire(USB)
8.Owners’ manual
9.Headphone socket
Layout of the back panel
2
1
3
To computer USB connector
To Audio output sockets
(computer/CD/MP3 etc.)
1.Signal input wire
2.DC input wire(USB)
3.Connecting line
1. Connect 3.5 mm stereo signal line to 3.5 mm stereo output interface of
a device such as computer, CD, MP3, etc. (see figure 2)
2. Connect the USB line to USB interface on the host computer.
(see figure 2)
3. Ensure all connections correctly, press the power switch on the speaker
system, and then play the music of audio equipment. Adjust the volume
control, Now you can enjoy the new multimedia speaker system.
This often happens on newly set up computers. There is sound from one
side when plugging the 3.5mm stereo mini-plug into the headphone jack
of CD-ROM. Because there is only one track of audio signal transmitted
from the audio equipment, please check the audio system carefully.
This system is magnetically shielded and it’s free from magnetic interfer-
ence even located near to the monitor or TV. But the amplifier magnetism
will cause magnetic interference or magnetization if the speakers is
located too close to the monitor or TV. Please locate the speakers at
least 30cm away from the monitor or TV.
(
Figure 2)
(
Figure 1)
Trouble shooting
Please refer to figure 1 and be sure you have all these items. Please
contact the retailer if any of these items are missing. Save this manual
for future reference.
Make sure to turn off your computer or audio equipment. Turn down all
volume controls before you start set-up procedure.
Summary of Contents for CSA20-AU
Page 1: ......
