IP iBase Standard and iCLASS Enhanced Keypad
19810016 REV C
Page 6
3. System Modes
3.1 Occupied Security Levels (Delayed or Instant) Mode
The Occupied security mode allows you to arm predefined areas of your premises (such as exterior
doors, windows, etc.) while the interior of the building remains occupied.
Two Occupied security levels are available:
•
Delayed: Select this feature when the premises are occupied and someone is expected to
enter. When the assigned delay door is opened, an "entry delay" time begins, allowing the
user ample time to enter the proper code into the keypad. The keypad beeps during this
time, reminding the user to enter a code.
•
Instant: Select this feature when the premises are occupied, and no one else is expected to
enter. If someone does enter through the delay door (or other predefined areas of your
premises) an alarm is immediately sent to the monitoring console.
3.2 Occupied Mode
1. Press ENTER while the cursor is pointing to OCCUPIED MODE.
2. While displaying OCCUPIED MODE, use navigation buttons to select either OCCUPIED -
INSTANT or OCCUPIED - DELAYED.
OCCUPIED MODE
>OCCUPIED - INSTANT
OCCUPIED - DELAYED
▼
3. While displaying SELECT PARTITION, use navigation buttons to select either THIS PARTITION
or MY PARTITIONS and press ENTER.
4. Keypad briefly displays PLEASE WAIT WHILE ARMING.... When armed, displays OCCUPIED -
INSTANT or OCCUPIED - DELAYED.
Note: XXX SEC TO EXIT will only display if the OCCUPIED - DELAYED has been
selected/optioned.
OCCUPIED - INSTANT
11/08/06 11:08
Note: MY PARTITIONS selection will attempt to arm to the Occupied Security Level only those
Partitions your access code has been programmed to control.
3.3 Chime Mode
When Chime Mode is enabled, the system will annunciate the violation of pre-selected devices while
security is disarmed.
3.3.1 Enabling Chime Mode
2.1 Use the navigation buttons to select TURN CHIME ON and press ENTER.
2.2 While displaying SELECT PARTITION, use navigation buttons to select either THIS PARTITION
or MY PARTITIONS and press ENTER.
Note: Keypad displays CHIME on the second line on the default screen when enabled.
3.3.2 Disabling Chime Mode
1. Use the navigation buttons to select TURN CHIME OFF and press ENTER.
2. While displaying SELECT PARTITION, use navigation buttons to select either THIS PARTITION
or MY PARTITIONS and press ENTER.
Note: Keypad will no longer display CHIME on the second line on the default screen.
