background image

 

 

connector. 

4. Carefully fill at least 1/2 of the tank with water and/or a cleaning solution. Based on 

cleaning requirements, we recommend using a small amount of our Eco4 cleaning 
solution because this will help increase the cleaning performance.    Press the side 

panel power switch to “ON” –

 this will turn the cooling fan and control box on.   

The cleaner is now ready for use. 

 
 

 

 

 

 

 

   

 

SAFETY PRECAUTIONS 

 

       
This device should not be used by individuals with limited physical knowledge, or those 
lacking training or knowledge, such as children unless they are supervised by an 
individual who can take charge of their safety or have received training in operating the 
device.                     
 

 

 

1

) DO NOT run the cleaner continuously for more than one hour at a time because it   

      can damage the internal components. 
2) DO NOT operate the unit without fluid in the tank. Always ensure that the solution is 
½ to 2/3 full. 
3) DO NOT drop any item into the tank because it may damage the transducers. 
Always place items gently into the tank and use the basket whenever possible. 

4) The more items you place into the cleaning bath, the less cleaning efficient you can     

      get.   
5) Do keep the lid on during use. This will prevent splashes and reduce evaporation 

      of the fluid. 

6) Never immerse the machine or power cord in water or other liquid. 
7) DO NOT touch the power plug with wet hands, especially when inserting or   
      removing the plug. 

Keep away from children ! 

Please  read  the  following  items  very  carefully  as  failure  to 
comply with them may void the warranty

 

 

Attention 

A) While the machine is working normally, the ultrasonic waves and tank give a 
well-proportioned sound and sprays generated by the tiny bubbles. If there are 
discontinuous surges, please add or reduce the solution in the tank to stop the surges, for 
a better cleaning effect.     

B) Please don

t operate for excessive cycle times (not more than 30 minutes suggested) as 

long  cycles  will  raise  the  temperature  of  the  bath  and  electronics  causing  premature 
failure.    Also, long cycle times will accelerate tank erosion which also leads to failures.

 

Summary of Contents for SR236









Reviews: