50
EN
8 Operation
8.2 Activate the display
During normal operation, only the temperature is shown on the display. In ECO mode the display
switches off completely. To activate the complete display, press below the temperature display.
8.4 Setting the time
Press the setting buttons „ “ and „ “ together for 3 seconds.
First, set the weekday with the and -buttons. Confirm your Choice with the button. Next,
set the hours and minutes using the same method.
8.1 Initial setup
To use the heater, proceed as follows:
• Connect the mains cable to the power circuit.
• Press the -button on the unit or the remote control.
• Then operate the device as described below.
8.3 Thermostat
You can set the desired temperature using the thermostat. To do this, press the -button
directly on the device below the temperature display. The temperature display now flashes. Use
the -buttons to set the desired temperature.
You can use the remote control to control the temperature with the
-buttons and confirm
your selection with the -button.
The heater is now in operation until the preset value is reached. The thermostat causes the
heater to switch on when the ambient temperature is below the preset value.
8.5 Switch off display / ECO-Mode
Press the and -buttons at the same time for 3 seconds or press the -button on the
remote to switch off the display.
To reactivate the display press below the display or press the -button on the remote.
Summary of Contents for 20110102
Page 13: ...Notizen Notes Nota...
Page 27: ...Notizen Notes Nota...
Page 41: ...Notizen Notes Nota...
Page 55: ...Notizen Notes Nota...
