36
EN
5 Operating instructions
Turn it on:
Plug the mains plug into a standard socket (220V~50Hz). Press the toggle switch
on the back, a beep should be heard. Press the On/Off button in the Control
Panel.
Set the temperature:
Press the two arrow keys on the control panel to set the temperature. The default
setting is 26º C and will flash on the display. You can set the desired temperature
from a minimum of 15º C to a maximum of 35º C. If no more keys are pressed,
the process is automatically completed and the display shows the current room
temperature.
Timer:
Press the “Timer” button to activate a timer of 1 h - 9 h.
Oscillation (Swing):
Press the “OSC” button to activate the automatic oscillation. The instrument will
now rotate left and right until you press the button again to deactivate the oscil-
lation.
Heating levels:
With the button “MODE” you can set the heating power between “High” 2000 W
and “Low” 1000 W by pressing once.
Ensure that the device is switched off before cleaning or maintaining it.
- Before maintaining, please pull out the plug, and make sure the heater has be-
come cool.
- Please use a soft cloth to wipe dust off the surface of the heater. If the surface
is too dirty, it is better to wipe it with water which is colder than 50° C and mixed
with a neutral detergent.
- Do not use gasoline, thinner or any other liquids which can easily damage the
surface.
- Please let the heater cool and dry before packing it. Place it in a dry and venti-
lated place.
4 Cleaning and maintenance
