55
4 Usage
• Take the product out of the packaging and fix the base plate with two screws.
• Connect the appliance to a socket outlet with the rated power indicated on the
rating plate (see section 5 „Features“ for details).
• Standby: Set the ON/OFF switch on the back of the appliance to the On position
to switch the heater to standby.
• Switch on: Press the power button (1) to switch on the heater. The temperature
is set to 23 degrees by default. If the temperature is higher than the default
temperature, the heater will not work. If it is lower than the standard tempera-
ture, the heater will start to heat.
• Power selection: Press the power selection button (2) to select the desired po-
wer. Press once: low power; Press twice: high power. Press three times: Heating
stops and works only as a fan.
• Swivel: Press the swivel button (3), the heater starts to swivel from left to right.
• Timer: Press the timer button (4) and select the + or - button to set the timer
from 1-12 hours.
• Fireplace: Press the fire effect button (6) and the fireplace switches on.
• Switch off: Press the power button to put the heater in standby mode. The fan
continues to run for 15 seconds (fan indicator light lights up). Put the ON/OFF
switch on display to switch off the heater completely.
1
2
3
4
5
6
7
EN
Summary of Contents for 20111001
Page 60: ...Notizen Notes Nota...
Page 61: ......
