46
47
The heating element is glowing The input voltage is too high or
too low
Use power supply according to
the rating on the label
The air inlet grille is blocked
Keep the heater far away from
objects like curtains, plastic
bags, paper and other things
which can easily cover the air
inlet
The appliance does not heat up,
only the ventilator works
The switch was not turned to set
the heat
Turn the switch to set the heat
The thermostat is active
Turn the thermostat and
listen if there is an open/close
noise. If there is no click and the
thermostat is not damaged, the
heater will automatically switch
on when the appliance has
cooled down.
The self-resetting cut-out was
activated
Turn the heater off and inspect
the blockage of the inlet or the
outlet. Disconnect the plug
and wait at least 10 minutes for
the protection system to reset
before attempting to restart the
heater.
Abnormal noise
The appliance does not stand
upright
Put the heater on a level surface
EN
Summary of Contents for 20600813
Page 50: ...Notizen Notes Nota...
Page 51: ...Notizen Notes Nota...
