32
EN
6.1 Start-up
To setup the oil radiator, proceed as follows:
•
Turn the heater upside down.
•
Position the wheelbase assemblies between the end ribs.
•
Fasten them to the heater with the U-bolts and wing nuts provided.
•
Tighten the wing nuts.
•
Turn the heater upside down in the correct direction.
6 How to use
6.2 Operation
OFR 7 LCD is equipped with a digital electronic control system that allows the temperature to be set
exactly to the desired level. To operate, simply follow these instructions.
Anti-tilt device:
Your radiator is equipped with an anti-tilt device that cuts off the power if the appliance is knocked
over. The anti-tipper prevents dangerous situations caused by overheating.
1.
Turn on the main switch on the side, a sound is heard, the control panel and LED light up for 1
second, then the heater is in standby mode. The red power symbol is displayed.
2. Press again
on the control panel, a sound is heard again, the heater now runs in P3 (high
level) and all buttons light up. The control panel displays the current ambient temperature. If
you press the power button again, the unit returns to standby mode.
3. When the oil radiator is in heating mode, press the
button to select the temperature
display in degrees Celsius or in degrees Fahrenheit. Press and hold the „MODE“ button to set
the respective heating level. P3 = high level, P2 = medium level, P1 = low level.
4. When the oil radiator is in heating mode, you can set your desired temperature with the „+“ and
„-“ buttons, selecting the range from 10° to 35° C. When the room temperature reaches your
desired temperature, the appliance is switched off. When the room temperature is lower than
the set temperature, the unit will switch on again. After 5 seconds, the system automatically
exits the setting status and displays the ambient temperature.
5. When the oil radiator is in heating mode, press the „TIMER“ button to enter the running time;
„OH“ is displayed on the screen. You can set the time directly using the „+“ and „-“ buttons,
with a range of 1 to 9 hours. After 5 seconds, the system automatically enters the countdown
and displays the ambient temperature again. When the timer expires, the unit automatically
switches to standby mode.
