4
Chapter 3 – PCIe Card Installation Steps
Figure 1
1.
Remove the Echo Express SE I - Thunderbolt 3 Edition (T3E) chassis
from its packaging, and then set it upside-down on a soft, flat, level
surface.
2.
Remove and set aside the four screws securing the feet to the
bottom of the outer case
(Figure 1)
. Set aside the screws
and feet.
3.
Turn the Echo Express SE I T3E chassis right-side up
(Figure 2)
.
4.
Place one hand on top of the outer case. Remove the
inner assembly by gently grasping its faceplate
by the edges and pulling
(Figure 2)
. Set
aside the outer case.
5.
Remove and set aside the screw used to secure a PCIe card from the
Echo Express SE I T3E chassis’ inner assembly
(Figure 3)
. If you are
installing a double-width card, or an additional daughter card, remove
and set aside the screw securing the port access cover, and then
remove and set aside the cover.
Support Note:
To avoid damaging components due
to static electricity discharge, wear an antistatic wrist
strap while working inside Echo Express SE I T3E.
Figure 2
Figure 3
Inner
Assembly
Outer
Case
