Ultrasonic cleaning process
© Sonoswiss AG
© Sonoswiss AG
BA_Modulrange_SW60/100/200_Sonoswiss_E_06.2012
19
5.2
Rinsing process SW 60 / 150 / 240 Rinser
By inserting the parts into the rinsing tank, the chemical residues will be rinsed. Thus, an
optimal cleaning result is guaranteed. The duration of the rinsing operation depends on the
amount and the mass of chemical residues on or in the parts and on the temperature of the
water medium.
5.3
Drying process SW 60 / 150 / 240 Dryer
By inserting the parts into the drying tank, the still adhering moisture at the parts after cleaning
resp. rinsing will be evaporated by a stream of hot air.
The duration of the drying process is determined by the amount of moisture on or in the parts
and their mass and on the temperature of the airflow.
The moist warm air will be dissipated from the dryer tank, so that dry air will re-flow into the
dryer tank.
5.4
Placement of the items to be cleaned
Caution!
Ultrasonic units are intended for the treatment of liquids and items immersed therein.
Do not treat living beings or plants in an ultrasonic unit, unless there is a substantial reason to
do so!
Do not reach inside the tank during ultrasonic operation!
Cell walls may be damaged by prolonged exposure to
ultrasonic activity; this applies particularly to the cells of the
skeleton and joints.
Do not place any cleaning items directly onto the floor of the
ultrasonic tank as this may cause damage to the ultrasonic
cleaning unit and/or of the cleaning items.
Place the cleaning items in the stainless-steel cleaning basket or
on the mesh (accessory).
NOTE
No cleaning items on
the bottom of the
tank
Use cleaning basket
