• connections & operations •
Micro Sub 8 • page 5
With all audio equipment OFF
1. If you are using Left, Right input of your subwoofer: Connect to these sockets
the 'Line out' of your preamplifier, amplifier, processor, or source. (Please
refer to the ‘Notes’ if you intend to use a high level input.) (Please refer to
Fig. 2 on page 4)
2. If you are using LFE input: Connect to this socket the ‘SUB OUT’ of your AV
receiver
3. Keep the Level control at 'Min,' and the Frequency control at approximately
3 o’clock setting.
4. Plug in the Mains Cord supplied to a 230V AC outlet which has a firm earth
connection.
5. Switch 'ON' your source and amplifier/preamplifier.
6. Switch on power to the system
7. Play a section of audio that you know has good low frequency (bass)
recording.
8. Turn up the volume of your amp/preamp till you attain a comfortable listening
level.
9. Now, slowly turn up the Level of your subwoofer till you reach the maximum
undistorted volume/ the level of bass that you desire.
10. Adjust the Frequency to find a setting that gives you the most satisfying
bass response (It would be a good idea to find out the low frequency limit of
your main speakers. This should allow you to have a more educated
approach towards setting the limiting frequency of your subwoofer).
