SSW 2010
•
page 6
1. INPUT SELECT SWITCH
This is a slide switch for input selection. When connecting the 4 Ohm speaker output of your amplifier
to the input of the SSW 2010, keep the switch in DIRECT mode. When connecting the 70V or 100V
output of your amplifier, keep it in 70/100V position.
2. MODE SWITCH
This is a slide switch for stereo/ mono mode. If you have connected to channels of your amplifier
output to the input of the SSW 2010, keep the mode switch in stereo position. If, however, the input
is mono, as for instance, 70/100V output of an amplifier, keep the switch in mono position. In
mono mode, the subwoofers are connected in series while the high-pass output is available from the
left channel only. Do not connect speaker to right input and amplifier output to right input as this may
cause malfunctioning.
3. DIRECT INPUT
Connect the 4 Ohm speaker output of your amplifier to these terminals. there is a pair of terminals
- one for left channel and the other for right channel. Take care to observe correct polarity while
making connections
4. SATELLITE OUTPUT
Connect your satellite speakers to these terminals. There is a pair of terminals - on for left channel
and the other for right channel. In stereo mode, the impedance of satellite speakers should be 4
Ohm for each channel. In mono mode, the satellite speaker connected to the left channel will only
play. The impedance of this speaker should be 8 Ohm.
5. 70/100V INPUT
Connect the 70/100V output of your amplifier to this terminal
It consist of a COM pin and 3 pins for different power taps. The power tap marking of 70V and 100V
are printed on the rear plate. Connect the amplifier to the COM pin and any of the power tap pins.
REAR VIEW
