3815WS 8.17WC
Precautions & Display Messages (cont.)
5. This scale is designed to weigh up to 11 lb x 0.1 oz / 5,000 g x 1
g/ 176 fl. oz. x 0.1 fl. oz. / 5,000 ml x 1 ml. To prevent damage,
do not place more than 11 lb / 5,000g / 176 fl. oz. / 5,000 ml on
it.
6. Do not store scale where you store cleaning chemicals. The
vapors from some household products may affect the electronic
components of your scale. Do not store scale on its side.
7. This scale is an extremely sensitive weighing device. In order to
prevent run down of the battery, do not store anything on the scale.
8. Unstable Warning: Should “
Err
” appear on the display, this
indicates the scale is unstable. Place the scale on a hard, level
surface during use.
9. Load Error: Should “
out2
” appear on the display, this indicates
too much weight has been placed on the scale before powering
on. Remove items from platform, turn on scale and wait for zero to
appear before weighing.
10. Overload Warning: Should “
oL
” appear on the display during a
weighing, this indicates that the maximum weighing capacity of
the scale has been exceeded. Remove the weight immediately;
otherwise, permanent damage could occur.
Caution: Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on. The user
is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
