4-3.
Front Panel
4-3-1.
Removal and Installation of Front Panel
1.
Loosen the two coin screws, and open the front panel.
2.
Disconnect the flexible flat cable from the connector CN1 on the AU-340 board.
Coin screws
Front panel
AU-340 board
CN1
Flexible flat cable
3.
Remove the step shaft, and remove the front panel from the shaft of the incom panel.
Front panel
Shaft
(Incom panel)
Step shaft
4.
Install the removed parts by reversing the steps of removal.
4-3-2.
CN-3451 Board
Preparation
1.
Open the front panel. (Refer to
“4-3-1. Removal and Installation of Front Panel”
Procedure
1.
Disconnect the harness from the connector CN2 on the CN-3451 board.
HDCU2500
4-13
Summary of Contents for 10001
