1-10
DNW-75/75P
DNW-65/65P
1-8. Signal Inputs and Outputs
1-8. Signal Inputs and Outputs
< Reduced drawing of rear panel >
Remote connectors
8
REMOTE PARALLEL I/O (50P)
D-SUB 50P connector (Refer to Optional “Interface manual” for details.)
9
VIDEO CONTROL
D-SUB 15P connector
for a TBC remote controller (BVR-50) connection
9
RS-232C
D-SUB 9P connector (RS-232C interface)
for ISR (Interactive Status Reporting)
9
REMOTE1-OUT (9P)
D-SUB 9P connector (RS-422A interface)
Remote control
9
REMOTE1-IN (9P)
D-SUB 9P connector (RS-422A interface)
Remote control
9
CONTROL PANEL
D-SUB (mini) 29P connector
for an outside control panel connection only
Input connectors
1
VIDEO INPUT, REF.VIDEO
BNC
x
2 in loop through connection
Outside reference video signal (Black burst or composite sync)
0.3 V p-p, 75
Z
, sync negative
1
VIDEO INPUT, COMPOSITE
BNC
x
2 in loop through connection
(DNW-75/75P only)
Analog composite video 1.0 V p-p, 75
Z
, sync negative
1
VIDEO INPUT, COMPONENT
BNC
x
3 (1 set : Y, R-Y, and B-Y)
(DNW-75/75P only)
Analog component video
Y
: 1.0 V p-p, 75
Z
, sync negative
R-Y/B-Y : 0.7 V p-p, 75
Z
3
SDI
BNC
x
1 (active through out
x
1)
(DNW-75/75P only)
Serial digital interface (270 Mbit/s), complies with SMPTE 259M & ITU-R BT.656
4
AUDIO INPUT
XLR3-pin
x
4 (1 set : CH1,CH2, CH3, and CH4)
(DNW-75/75P only)
Analog audio 4 channels
LOW OFF :
_
60 dBu, high impedance, balanced
HIGH OFF :
+
4 dBu (Standard), high impedance, balanced
HIGH ON
:
+
4 dBm (Standard), 600
Z
termination, balanced
5
TIME CODE IN
XLR3-pin
x
1
(DNW-75/75P only)
Time code 0.5 to 18 V p-p, 10 k
Z
, balanced
7
AUDIO INPUT (AES/EBU)
BNC
x
2 (1 set : CH1/2 and CH3/4)
(DNW-75/75P only)
Digital audio 4 channels
AES/EBU format, complies with AES-3id-1995
1
4
5
7
9
8
6
2
3
!/
