1-25
DNW-75/75P
DNW-65/65P
1-16. Taking Out the Cassette in Tape Slacking
5.
Rotate the M gear of the threading motor block in the
direction of the arrow with the fingers by about a half
turn to slack off the tape.
6.
Pull the ME lever toward the front panel side to take
up the tape inside the cassette.
7.
To wind up the tape, repeat steps 5 and 6.
8.
Pull the lower control panel slightly forward, then pull
it more strongly to tilt the lower control panel upward
(to 90d position).
9.
Turn the wheel of the cassette compartment motor
clockwise as shown in the figure until the cassette is
ejected completely.
1-16. Taking Out the Cassette in Tape
Slacking
When the tape is slacked in this unit, follow the steps
below to take out the cassette tape.
n
Being careful not to damage the tape, take out the cassette
tape with care.
1.
Turn off the power.
2.
Remove the upper lid.
(Refer to steps 1 and 2 in Section 1-15.)
3.
Slide the knobs on the plate MD assembly each in the
inside. (Move the knobs to the outside to fix the plate
MD assembly.)
4.
Remove the plate MD assembly.
n
Be careful not to pinch the harnesses under the plate
MD assembly in reattaching.
Knob
Knob
Installation
Removal
Plate MD assembly
Plate MD assembly
Harnesses
Up
Down
Cassette compartment
Wheel
Cassette
compartment
motor
M gear
Threading motor
ME lever