DV
D
Re
co
rd
in
g
51
Notes
• Recording may not start immediately after
z
REC is
pressed.
• You cannot change the recording mode during
recording or recording pause.
• If there is a power failure, the programme you are
recording may be erased.
• You cannot change the programme position or input
source during recording.
Recording using the Quick Timer
(One-touch Timer Recording)
You can set the recorder to record in 30-minute
increments.
1
Press DVD to operate the DVD recorder.
2
Press
z
REC repeatedly to set the
duration.
Each press increases the time by 30 minutes,
up to eight hours*.
“
c
” and “OTR” light up, and the remaining
recording time appears in the front panel
display.
When the counter reaches “0:00,” the recorder
stops recording and turns off.
* 14 hours 30 minutes for DVD+R DL (Double Layer)
discs.
To cancel the Quick Timer
Press
z
REC repeatedly until the counter appears
in the front panel display. The recorder returns to
normal recording mode.
To stop recording
Press
x
twice.
Note that it may take a few seconds for the
recorder to stop recording.
Checking the disc status while
recording
You can check the recording information such as
recording time or disc type.
Press DISPLAY during recording.
The information display appears.
Press the button repeatedly to change the display
(page 47).
A
Disc type
B
Recording status
C
Recording time
D
Recording mode
E
Remaining disc space
F
Programme position or input source
Creating chapters in a title
The recorder will automatically divide a recording
(a title) into chapters by inserting chapter marks at
5 or 15-minute intervals during recording. Select
the interval, “5 min” (default) or “15 min” in
“DVD Auto Chapter” of “Features” setup
(page 107).
If you do not want to divide titles, select “Off.”
0:30
1:00
7:30
8:00
(Normal
recording)
Record
0:00:03
HQ
Rem 00:59
Prog. 1
Summary of Contents for 3-213-480-12(1)
Page 131: ......
Page 132: ...Sony Corporation Printed in Indonesia AK68 01481A ...
