115
GB
Ad
justi
ng Se
ttings
Notes
• It takes some time to output the sound after a
playback operation is performed on the connected
component (e.g., pressing the PLAY button,
pressing the STOP button, pressing the PAUSE
button) due to limitations of the H.A.T.S. system.
The time lag depends on the sound source. This
feature may be ineffective depending on the
component and the sound source, even if you set it
to ON.
• The components connected to the HDMI jack must
support the H.A.T.S. feature.
• When “Audio Out” is set to “TV+AMP,” the
H.A.T.S. function may not work depending on the
component connected or the condition of that
component. In this case, select “AMP” for “Audio
Out.”
• The H.A.T.S. function of this receiver works when
a Sony SCD-XA5400ES is connected to the
receiver.
Stream information about the
H.A.T.S. function available
Lets you output the video input signals from
the HDMI IN jack directly to the HDMI OUT
jack.
x
OFF
The input signals from the HDMI IN jack are
output through a video processor.
x
ON
The input signals from the HDMI IN jack are
output directly.
Network settings
Makes the settings for the network. Refer to
“Using Network Features” supplied with these
operating instructions for details.
Lets you activate the server function of the
receiver.
x
OFF
x
ON
Lets you make the network settings.
x
Network Information
x
Network Setup
x
Proxy Setup
x
Cancel Network Setup
Audio signal input Sampling frequency
Linear PCM 2ch
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
Linear PCM Multi
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
DSD
2.8224 MHz
Video Direct
Server Function Setup
Network Setup
