Answering Machine Features
Answering Machine Features
67
US
Picking up new messages
1
Call your phone from a touch-tone phone.
2
While you hear your greeting play, press
(#)
. The greeting
stops.
After confirming the greeting stops, enter your remote ID
code (security code). You hear a long confirmation beep.
Following the voice guidance informing you of the number
of messages recorded, the phone stands by for you to enter a
control code.
3
To do other operations, enter the control code within 20
seconds (see the table below). To quit, hang up the phone.
Control codes for remote operations
To
Press
Play back messages
(#)
(2)
Repeat the current message
(#)
(1)
while the message is being played back
Skip the current message
(#)
(3)
while the message is being played back
Erase the current message
(#)
(9)
while the message is being played back
Erase all messages
(#)
(9)
Record a new greeting
(*)
(7)
. When you hear a long beep, start recording your
(up to one minute)
greeting. Press
(*)
(*)
to stop recording.
Turn on the answering function
(*)
(0)
Turn off the answering function
(#)
(0)
Stop the current operation
(*)
(*)
If you forgot to turn the answering function on
Call your phone and let it ring 10 times until it answers. Then do steps
2 and 3 above. The control code for turning on the answering function
is
(*)
and
(0)
.
Note
If you enter a wrong remote security code three times, the line will be
disconnected.
To use the toll-saver feature
Set “RINGER TIMES” to “TOLL SAVER”. See page 54 for details.
