16
AM-NX1
Sound Skip Check Result Display Mode
This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 12).
2. Press the
>
key and the playing or recording sound skip
result display mode becomes active respectively where the LCD
displays the following.
3. When the
N
key is pressed, total error count is displayed on
the LCD, and each time the
>
key is pressed, the display
item moves down by one as shown below. Also, if the
.
key
is pressed, the display item moves up by one.
• Cause of Sound Skip Error
Cause of error
Description of error
EIB
Sound error correction error
Play
Stat
Decoder status error
Adrs
Address access error
BEmp
Buffer is empty
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the
x
key.
LCD display
P * * R * *
000
Total count of play
system errors (hex.)
Total count of record
system errors (hex.)
0
00
P * * R * *
0
00
E I B * *
0
00
S t a t * *
0
00
A d r s * *
0
00
B E m p * *
0
00
# # # # # #
P**R**
: Total play/record errors (hex.)
**
: Counter of sound skip check each item (hex.)
######
: 6-digit address where sound was skipped last (hex.)
Playing sound skip
result display
• Setting Method of Key Check Mode
1. Set the test mode (see page 12).
2. Press the
[DISPLAY]
key for about 3 seconds activates the
key check mode and display as below.
3. When each key on the set is pressed, its name is displayed on
the LCD.
Example1: When the
>
key on the set is pressed:
4. When all keys were checked, display as below.
5. If the upper panel is opened, the key check mode quits and the
test mode (display check mode) comes back.
LCD display
**
: value of key (hexadecimal 00 to FF)
* *
000
LCD display
**
: value of key (hexadecimal 00 to FF)
r F F * *
000
LCD display
**
: value of key (hexadecimal 00 to FF)
R M C O K * *
000
Summary of Contents for AM-NX1
Page 36: ...36 AM NX1 MEMO ...