1-1 (E)
BDX-E1000
Section 1
Installation
1-1. Installation Environment
1.
Do not install the BDX-E1000 in the following
locations.
• Areas where the unit will be exposed to direct sun
light or any other strong lights.
• Dusty areas or areas where it is subject to vibration.
• Areas with strong electric or magnetic fields.
• Areas near heat sources.
• Areas where is subjected to electricity noise.
• Areas where is subjected to static electricity noise.
2.
To prevent the temperature rise inside the BDX-
E1000, pay careful attention to circulation of air in the
place where the BDX-E1000 is installed.
The rear side of the BDX-E1000 should be at least
20 cm away from walls for ventilation and
maintenance.
c
Do not block the ventilation holes.
If the ventilation holes are blocked, the temperature inside
the BDX-E1000 getting rise. This may cause a fire.
1-2. Power Supply
1-2-1. Power Specifications
Power requirements : 100 to 240 V AC
50/60 Hz
Current consumption : maximum 2.0 A (at 100 V)
maximum 1.0 A (at 240 V)
A switching regulator is used for the power supply of the
BDX-E1000. The voltage within the range of 100 V to
240 V can be used without changing the supply voltage.
n
As the inrush current at turn-on is maximum 20 A (at
100 V)/maximum 40 A (at 240 V), the capacity of the AC
power must be adequate with the inrush current of
maximum 20 A (at 100 V)/maximum 40 A (at 240 V).
If the capacity of the AC power is not the adequately large,
the breaker of the AC power at the supply side will operate
or the BDX-E1000 will abnormal operate.
1-2-2. Power Cord
w
To avoid a fire or an electric shock, be sure to use the
designated power cord.
And do not damage to the power cord.
n
For the customer outside of the area as shown above or in a
part of Europe, the above-mentioned power cords con not
be used.
Use the power cord that is applicable to the places in the
world.
1
2
2
2
Power cord for the customer in the U.S.A. and Canada.
1
Power cord set
!
1-557-377-11
2
Plug holder (Black)
2-990-242-01
Power cord for the customer in the United Kingdom.
1
DK-2401 (UK) (approx. 2.4 m)
2
Plug holder (Black) 2-990-242-01
Plug holder is included in DK-2401 (UK).
Power cord for the customer in Europe except the
United Kingdom.
1
DK-2401 (AE) (approx. 2.4 m)
2
Plug holder (Brown) 3-613-640-01
Plug holder is included in DK-2401 (AE).
AC inlet
AC inlet
1
AC inlet
1
