Chapter 4
Playback
Chapter 4
Playback
4-5
4-2-6 Carrying Out Playback in
Feed Mode
You can use feed mode to play back a Betacam SX
tape by setting item 111 in the extended menu to
“FEED.” The playback output (an SDTI(SX) signal or
SDTI-CP signal, depending on the installed board) is
output from the SDTI OUTPUT connectors.
Use the following procedure to carry out feed mode
playback.
1
Hold down the DMC MODE button, and turn the
search dial to set the playback speed.
When the BKNW-118 (optional SDTI(SX)
output board) is installed
The playback speed can be set to 0.1 to 2.0 times
the normal speed, in steps of 0.1.
When the BKNW-124 (optional SDTI-CP
output board) is installed
The playback speed can be set at either normal
speed or twice the normal speed.
While you hold down the DMC MODE button, the
playback speed setting for feed mode appears in
the speed display area as a multiple of normal
speed. (For example, twice normal speed is shown
as “2.00”. The initial setting is “1.00.”)
2
Hold down the DMC MODE button, and press the
PLAY button.
Both buttons light, and playback in feed mode
starts.
Speed display area
2
3 1
9
)
0
6
p
%
3
Where you wish to stop playback, press the STOP
button.
Playback in feed mode stops.
Auto-feed playback
When the optional BKNW-124 SDTI-CP output board
is installed, this VTR can play back from a specified
IN point to a specified OUT point in feed mode. You
can connect another recorder capable of stand-by
recording (e.g., MAV-555/2000) through the SDTI-CP
interface to carry out dubbing from the IN point to the
OUT point.
1
Press the CTL/TC/UB button on the front panel
repeatedly to select TC (time code) as the time data
to be displayed on the fluorescent display.
2
Hold down the ENTRY button and press the IN (or
OUT) button at the place you wish to set the IN (or
OUT) point.
3
Hold down the DMC EDIT/FEED button and press
the PREVIEW button.
This VTR prerolls to a point 5 seconds before the
IN point, and then starts playback in feed mode
(preroll time can be changed using item 001 in the
basic menu). The VTR postrolls to a point 2
seconds after the OUT point, and then stops.
The portion between the IN point and the OUT
point is recorded on the connected recorder.
You can set the playback speed for auto-feed
playback in the same way as the playback speed in
feed mode.
Summary of Contents for Betacam SX DNW-A65
