2-3 (E)
BKSM-T103
3. Connection of Coaxial Cable and Harness
.
When the rear panel with 3-pin XLR connectors is used :
(1) Connect the coaxial cable to the BNC connector.
(2) Route the coaxial cable as shown in the figure.
(3) Connect the coaxial cable to CN100 (A-3) on the APR-30 board.
(4) Connect the harness (white) to CN1 on the CP-309 board.
(5) Route the harness as shown in the figure.
(6) Connect the harness (white) to the CN900 (A-6) on the APR-30 board.
<Connection>
Coaxial cable
: BNC connector
_
CN100/APR-30 board
Harness (white) : CN1/CP-309 board
_
CN900/APR-30 board
2-1. Installation of Board and Rear Panel
CN900 (white)
CN100
CN900 (white)
CN100
APR-30 board
APR-30 board
CP-309 board
CN1 (white)
CN1 (white)
BNC connector
CP-309 board
BNC connector
Harness clamper
1
: When the board is installed in “1” side
2
: When the board is installed in “2” side
1
2
1
2
Summary of Contents for BKSM-T103
