30
GB
D:\SONY TV\SY150029_SE2SE2N PAD IM (Rev-1)\4562311121\070OPT.fm
masterpage: Left
KDL-48R560C / 48R558C / 48R550C / 40R560C / 40R558C / 40R550C / 32R500C / 32R410C / 32R408C
4-562-311-
12
(1)
Using Audio and Video
Equipment
1
Turn on the connected equipment.
2
Press
to display the input source.
3
Press
/
then
to select the desired
input source.
The highlighted item is selected if 5 seconds
pass without any operation.
Note
• When connecting a digital audio system not
compatible with Audio Return Channel (ARC)
technology using an HDMI cable, you need to connect
an optical audio cable to the DIGITAL AUDIO OUT
(OPTICAL) to output digital sound.
• When connecting with an HDMI cable, be sure to use
HighSpeed HDMI Cable with Cable Type Logo
(Recommended SONY Cable).
• When connecting mono equipment, connect the
audio cable to the L (mono) jack.
• When connecting a device that has DVI output,
connect the DVI HDMI video cable to the HDMI IN 2
(DVI) and the DVI HDMI audio cable to the HDMI 2
AUDIO IN jack.
To use BRAVIA Sync devices
When connecting the TV to BRAVIA Sync
compatible equipment, you can control them
together.
Be sure to perform the necessary settings in
advance. The BRAVIA Sync Control settings must
be set on both the TV and the connected
equipment. See [BRAVIA Sync Settings]
(page 26) for the settings on the TV side. Refer
to the connected equipment operating
instructions for the settings on the connected
equipment side.
Using Screen mirroring
(except KDL-32R410C, KDL-32R408C)
Screen mirroring displays the screen of a
compatible device (e.g. smartphones) on your
large TV screen by Miracast technology.
No wireless router (or access point) is required
to use this feature.
1
Press the
/
button, then select
[Screen mirroring] using
/
buttons.
2
Operate the Screen mirroring
compatible device to connect with the
TV. Once connected, the screen will be
displayed on the device and also TV.
For details, refer to the instruction
manual of the device.
To show connected devices/deregister device
When the standby screen for the Screen
mirroring is displayed, press
OPTIONS
, then
select [Show Device List / Delete].
To deregister a device, select the device in the
list to delete, press
. Then, select [Yes] in the
confirmation display.
To display registration notification when
attempting to connect a device with the TV
Activating this function can avoid an
unintended device from being connected.
When the standby screen for then Screen
mirroring is displayed, press
OPTIONS
, then
select [Registration Notification]
[On].
Note that once you decline registration request
from a device, you will not be able to connect
the device unless you delete it from the device
list.
To change the band setting (for experts)
When the standby screen for Screen mirroring is
displayed, press
OPTIONS
, then select [Band
Setting].
Note
• Connecting devices must conform to the following:
Screen mirroring compatible devices:
2.4 GHz connection (5 GHz not supported).
• For information about the supported wireless band of
your device, refer to the instruction manual of your
device.