KDF-46E2000/46E2010/50E2000/50E2010/55E2000/55E2010
KDF-46E2000/46E2010/50E2000/50E2010/55E2000/55E2010
13
READING LAMP AND PANEL TIME
The TV_Micro menu of the Service Menu displays the current lamp and
panel time of a set. The Lamp Hours and Panel Hours are shown in
hexadecimal format.
1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote Commander within a
second of each other:
DISPLAY
Channel
5
Volume
+
POWER .
One of the three Service Menu displays. (For more information
regarding the Service Menus, see
2-2. Accessing Service Adjustment Mode.)
VERSION 0
0
SERVICE
VERS
Wide Zoom Video 1
WSL: 480I
3. To read the Lamp time, press 4 to display the
TIME
category and the
LMPH
item.
The screen displays:
Wide Zoom
TV
TIME 0
0
SERVICE
LMPH
LMPH: 01H
LMPL: A0H
Total LAMP TIME is
416
hours
Total hours 256 Total hours 160
4. To read the Panel time, press 4 to display the
PHLH
item.
Wide Zoom
TV
TIME 0
0
SERVICE
PNLH
PNLH: 01H
PNLL: A0H
The screen displays:
Total PANEL TIME is
416
hours
Total hours 256 Total hours 160
5. Do one of the following:
a. If you have replaced the lamp, proceed to step 4 of “Resetting the
Lamp Time”.
b. If you have not replaced the lamp, turn off the set by pressing
POWER
RESETTING THE LAMP TIME
When replacing the lamp, use the following to reset the lamp time.
1. If the Self-Diagnostic screen is already displayed, proceed to step 4.
If not, Power off (Set to Standby mode).
2. Press DISPLAY
Channel
5
Sound Volume -
POWER
3. To access the Lamp reset, press 5 until the
TIME
category displays.
4. Press 1 until the
RSET
item displays.
Wide Zoom
TV
TIME 0
0
SERVICE
RSET
5. To reset the Lamp time, press 3 to change the data value to 1.
Wide Zoom
TV
TIME 0
1
SERVICE
RSET
6. Press MUTING
ENT to write the change into memory.
Wide Zoom
TV
TIME 0
1
WRITE
RSET
6. To verify the Lamp has been reset press 5 until the
TIME
category
displays, and then press 1 until the
LMPH
item displays.
NOTE: You cannot reset the Panel time with the Service menu.
EXITING SERVICE MODE
After completing the changes, exit service mode by turning off the set
using the Remote Commander or the power switch.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.