KDL-24R400A/32R400A 15
SECTION 3 - REPAIR INFORMATION
4. Remove 5 screws and lift to detach board from Rear Cover.
5. Install the new Main Board and 5 screws.
6. Reconnect the LVDS cable and all other connectors:
CAUTION: Make sure the black line is aligned to the connector before
locking.
For KDL-24R400A
a. Insert LVDS cable in the connector and close black locking bar to
secure position.
For KDL-32R400A
b. Press both sides to clamp connector and insert back.
7. Holding the FFC cables, insert into the connector and secure position.
REPLACING THE MAIN BOARD
The Main Board used in these models is available for repair. For Part
Number information refer to
Section 4 - Exploded View/Part Number
1. Disconnect LVDS cable according to the TV model:
For KDL-24R400A
a. Lift the black locking bar and pull LVDS cable to release.
For KDL-32R400A
b. Press both sides to unclamp connector and pull to release.
2. To disconnect FFC cables lift the black locking bar and pull to release.
3. Disconnect all the remaining connectors.
