KDL-42W650A 16
SECTION 3 - REPAIR INFORMATION
32. Clear the
Self Check
screen.
a. Press
POWER
to exit
Service Mode.
b. Press the following buttons on the
Remote Commander
within 1
second of each other:
DISPLAY
Channel
5
Volume
-
POWER
SELF CHECK
000 RESERVED
--------------------- --------------------- --------------------- 00
000 RESERVED
--------------------- --------------------- --------------------- 00
002 MAIN_POWE --------------------- --------------------- --------------------- 00
003 DC_ALERT
--------------------- --------------------- --------------------- 00
003 AUD_PROT
--------------------- --------------------- --------------------- 00
003 HDMI_EQ
--------------------- --------------------- --------------------- 00
003 TU_DEMOD --------------------- --------------------- --------------------- 00
004 VLED
--------------------- --------------------- --------------------- 00
004 LD_ERR
--------------------- --------------------- --------------------- 00
005 HFR_ERR
--------------------- --------------------- --------------------- 00
005 TCON_ERR
120123132522 120123113645 --------------------- 02
005 P_ID-ERR
--------------------- --------------------- --------------------- 00
006 BACKLITE
--------------------- --------------------- -------------------- 00
007 TEMP_ERR
--------------------- --------------------- --------------------- 00
007 FAN_ERR
--------------------- --------------------- --------------------- 00
010 EMITTER
--------------------- --------------------- --------------------- 00
101 VPC_WDT
--------------------- --------------------- --------------------- 00
102 MEPS_WDT --------------------- --------------------- --------------------- 00
103 HOST_WDT --------------------- --------------------- --------------------- 00
104 STBY_WDT
--------------------- --------------------- --------------------- 00
00345 000333 06789
Error Count
c. To clear the error history and error count press
8
0
.
d. Press
POWER
to exit
Self Check Mode.
33. Cycle AC Power (Unplug and plug AC Cord from the outlet).
REMOVING THE SPEAKERS
1. Press down the connector clip to disconnect.
NOTE:
For the Speaker Box Right you must also disconnect the Switch
Unit connector.
2. Remove screws and lift the Speaker Box to detach.
REPLACING THE SWITCH UNIT
1. Remove screws and press as shown to remove the Switch Unit.
2. Install the new Switch Unit, screws and connectors.
