Font Size
Using Internet
Services and
Applications
Watching TV with
Friends Far and
Near
> Network Connectivity Test Results
Network Connectivity Test Results
The test results are “Failed”/“Failed”/“Failed”.
The test results are “OK”/“Failed”/“Failed”.
The test results are “OK”/“OK”/“Failed” or “OK”/“OK (IPv6 Only)”/“Failed”.
The test results are “OK”/“OK (IPv6 Only)”/“OK (IPv6 Only)” or
The test results are “Failed”/“Failed”/“Failed”.
When using the wired LAN function, make sure that the cable is firmly
connected.
When using the wireless LAN function, unplug the TV from the AC power,
wait for a while, then plug it in again.
The test results are “OK”/“Failed”/“Failed”.
The router function of your router may be turned off. Turn it on and try
again.
When using the wireless LAN function, check the items below:
- An incorrect security (WPA or WEP) key may have been entered. Make
sure that the correct security key is entered.
- If you select a network (SSID) from the scan list, ensure that you select a
correct network (SSID). If you enter an SSID manually, make sure that
you enter the correct SSID.
- To find the correct security key and SSID, consult with the person who
set up your network or refer to the router’s instruction manual or website,
or consult the router’s manufacturer.
- If you configured the TV’s wireless LAN function to connect to a wireless
router (or access point) at 5GHz, the connection with the wireless router is
disconnected while [Wi-Fi Direct] is [On]. When you turn off [Wi-Fi Direct],
the connection will automatically recover.
221
