masterpage:3 columns Right
16
F:\Worker\SONY TROY2 ANA EN 12(1)\2694282121\01US03WEL.fm
KF-42/50E200A
2-694-282-
12
(1)
TV Controls and Connectors
Front Panel
Item
Description
1
MENU
Press to display
MENU
to activate the
,
B
,
b
,
v
, and
V
buttons. Press again to exit
MENU
to
activate the
TV/VIDEO
,
–
and
–
buttons.
2
TV/VIDEO
Press to confirm the selection or setting.
Press repeatedly to cycle through the video equipment connected to the TV’s video inputs.
3
–
Press to adjust the volume.
4
– C
Press to scan through channels. To scan quickly through channels, press and hold either
–
or
+
.
5
TIMER LED
When lit in orange, indicates one of the timers is set. When it is set, this LED will remain lit even if
the TV is turned off. For details, see page 62.
6
LAMP LED
Flashes in red when the lamp for the light source has burned out. For details, see “Replacing the
Lamp” on page 66.
7
POWER
Lights up in green when the TV is turned on. If the LED blinks in red continuously, this may
indicate the display unit needs servicing (see contacting Sony information on page 2). When the red
LED blinks only three times, the lamp door of the lamp unit or the lamp itself is not securely
attached (see page 67).
8
Infrared
Receiver
Receives IR signals from the remote control.
Do not put anything near the sensor, as its function may be affected.
9
POWER
Press to turn on and off the TV.
q;
Speaker
Outputs the audio signal.
✍
The C button has a tactile dot. Use the tactile dot as a reference
when operating the TV.
PUSH OPEN
MENU
TV/VIDEO
CANNEL
VOLUME
POWER
TIMER
LAMP
POWER/STANDBY
PUSH OPEN
POWER
POWER
MENU
TV/VIDEO
CHANNEL
VOLUME
TIMER
LAMP
2
1
5
9
3
4
6
7
8
0
0
To open the front panel of your TV, push up the
panel door just under the “PUSH OPEN” mark.
To open the panel
