masterpage:3 columns Right
55
U
s
ing
the
Setting
s
F:\Worker\SONY TROY2 ANA EN 12(1)\2694282121\01US07MEN.fm
KF-42/50E200A
2-694-282-
12
(1)
Full 2
Select to enlarge the picture to fill the display
area.
✍
A black frame will appear on the surrounding of
the picture.
Zoom
Select to enlarge the picture horizontally and
vertically to an equal aspect ratio that fills the
wide screen.
Auto Wide
On
Select to automatically switch the wide mode
based on the input signal.
Off
Select to keep the Wide Mode in its original
size and aspect ratio.
✍
This option is not available for HDMI PC input.
4:3 Default
Select the default
screen mode to
use for 4:3
sources.
Wide Zoom
Select to enlarge the 4:3 picture, to fill the 16:9
screen, keeping the original image as much as
possible.
Normal
Select to return the 4:3 picture to its original
size and aspect ratio.
Full
Select to enlarge the 4:3 picture horizontally
only, to fill the display area.
Zoom
Select to enlarge the picture horizontally and
vertically to an equal aspect ratio that fills the
wide screen.
Off
Select to continue using the current screen
mode setting when the channel or input is
changed.
✍
This option is not available for HDMI PC input.
✍
This option is not available if Auto Wide is set to
Off.
Display Area
Select
Normal
to return to the default display area. Select
-1
or
-2
to enlarge the picture vertically and horizontally.
✍
Display Area option is not available when PC
Wide Mode is set to Normal.
Horizontal
Center
Allows you to move the position of the picture left and right in
the window.
Press
B
or
b
and to choose a correction b5 and –5.
Vertical Center
Allows you to move the position of the picture up and down in
the window. (Available only in
Wide Zoom
,
Zoom
and PC
Wide modes.)
Press
V
or
v
and press
to choose a correction b5
and –5.
Vertical Size
Allows you to adjust the vertical size of the picture. (Available
only in
Wide Zoom
,
Zoom
and PC Zoom modes.)
Press
V
or
v
and press
to choose a correction b5
and –5.
Option
Description
z
If 4:3 Default is set to
anything but Off, the
Wide Mode setting
changes only for the
current channel. When
you change channels
(or inputs), Wide Mode
is automatically
replaced with the 4:3
Default setting. To retain
the current Wide Mode
setting as channels and
inputs are changed, set
4:3 Default to Off.
