22
GB
KLV-22S570A
4-142-343-
11
(1)
Intelligent Picture
“On with Indicator”:
Automatically reduces the picture noise. The signal level bar is
displayed when the channel is changed or the display is changed from an input screen
to a TV programme.
“On”:
Automatically reduces the picture noise.
“Off”:
Turns off the “Intelligent Picture” feature.
•
When “Off” is selected, it will automatically turns off the “Signal Booster” function.
Manual Programme
Preset
Before selecting “Label”/“AFT”/“Skip”/“Colour System”/“Signal Booster”, press
PROG +/- to select the programme number with the channel. You cannot select a
programme number that is set to “Skip” (page 22).
Programme/TV System/VHF or UHF
Presets programme channels manually.
1
Select “Programme”, then press
.
2
Press
F
/
f
to select the programme number you want to manually tune
(if tuning a VCR, select channel 000), then press RETURN.
3
Press
F
/
f
to select “TV System”, then press
.
4
Press
F
/
f
to select your TV broadcast systems, then press
.
5
Press
F
/
f
to go to the frequency range indication (“VHF Low”, “VHF High” or
“UHF”), then press
.
6
Tune the channels as follows:
Press
G
/
g
to search for the next available channel. When a channel has been found,
the search will stop. To continue searching, press
G
/
g
.
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected channel.
This name will be displayed briefly on the screen when the channel is selected.
To input characters, follow steps 2 to 4 of “Programme Labels” (page 21).
AFT
Allows you to fine-tune the selected programme number manually if you feel that a
slight tuning adjustment will improve the picture quality. You can adjust the fine tuning
over a range of -15 to +15. When “On” is selected, the fine tuning is performed
automatically.
Skip
Skips unused channels when you press PROG +/- to select channels. (You can still select
a skipped channel using the number buttons.)
Colour System
Selects the colour system (“Auto”, “PAL”, “SECAM”, “NTSC3.58”, “NTSC4.43” or
“PAL60”) according to the channel.
Signal Booster (Intelligent Signal Booster)
Improves the picture quality if the TV signal is too strong or weak.
Press
F
/
f
to select either “Off” if the signal is too strong (picture distorted; picture with
lines; signal interference) or “Auto” if the signal is weak (snowy picture), then press
.
Signal Level
Displays the signal level for programme currently being watched.
red
(weak)
amber
(average)
green
(good)
Summary of Contents for BRAVIA KLV-22S570A
Page 27: ......
