D:\SONY TV\SY140117_Clover 55 (Rev-3)\4533567E31_US\US03STU.fm
XBR-79X907B/79X905B/65X907B/65X905B
4-533-567-
E3
(1)
12
To detach the Table-Top Stand from the TV,
remove the screws
.
~
•
Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
•
Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
•
When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.
If you do not wish to use the camera, hide it
as illustrated.
2: Connecting the TV
~
•
Use an antenna cable connector no greater
than 14 mm thick.
•
When connecting the cable to the cable/
antenna, input finger tighten only, over
tightening the connection can damage the
TV.
•
Before moving the TV, disconnect all of the
cables connected to the TV to prevent
damaging the TV when it is moved.
•
Use an HDMI cable connector within 12 mm
(thickness) × 21 mm (width).
•
Use Sony HDMI cable with “High Speed”
indication for HDMI connection.
•
For connection with Port Replicator, refer to
the installation guide supplied with the Port
Replicator.
•
For more information on connections, refer to
the i-Manual.
Detaching the side and rear terminal
covers
The side and rear terminal covers are
factory-attached to the TV.
Before connecting cables, remove the side
and rear terminal covers.
~
•
After connecting all cables, re-attach the
side terminal cover to the TV. For the rear
terminal cover, be sure to store the removed
cover in a safe place, keeping it away from
children.
Detaching the Table-Top
Stand from the TV
Hiding the camera
Camera cover
Side terminal cover
Rear terminal cover
