Sony BTA-NW1, Operating Instructions Manual

6-

GB

Precautions

The set is not disconnected from the AC power source (mains) as long as it is connected
to the wall outlet, even if the set itself has been turned off.

Installation/storage

Do not place the unit in locations that are:
• Extremely hot such as in a car parked in the sun
• Under direct sunlight or near sources of high temperature, such as a heating device
• Subject to strong vibration
• Near devices which generate strong magnetic fields
• Dusty or dirty

When you use the unit on a sandy beach or in a dusty place, protect it from the sand
or dust. Sand or dust may cause your unit to malfunction.

Operation

• Do not use the unit in an aircraft, hospitals or petrol stations.
• Do not use the unit near devices (such as radios) which transmit strong radio waves.
• Keep the unit away from radio or TV sets.
• Do not use cards other than the exclusive modem card.
• Do not use the exclusive modem card with devices other than this unit.

Size AA alkaline dry batteries

• The batteries may get hot just after using the unit. Wait until their temperatures fall

and remove the batteries.

• If you do not intend to use the unit for a long time, remove the batteries.
• Do not mix old and new batteries, or different types of batteries.
• Be sure to use Sony size AA alkaline dry batteries. Using other batteries may decrease

the level of unit performance.

• When you attempt to use the unit in low temperatures, use the supplied AC power

adaptor. Use in low temperatures causes significant battery performance degradation.

• Be sure not to use the following types batteries: nickel-cadmium, nickel metal hydride,

manganese, or primary lithium batteries.

Cleaning

• Clean the unit surface with a soft cloth slightly moistened with mild detergent, then

wipe the surface dry.

• Do not use any type of solvent such as thinner, alcohol or benzene as this may damage

the finish or the casing.

On the supplied AC power adaptor

• Unplug the unit from the wall outlet (mains) when you are not using the unit for a

long time. To disconnect the power cord (mains lead), pull it out by the plug. Never
pull the power cord (mains lead) itself.

• Do not operate the unit with a damaged power cord (mains lead) or if the unit has

been dropped or damaged.

• Do not bend the power cord (mains lead) forcibly, or place a heavy object on it. This

will damage the power cord (mains lead) and may cause fire or electrical shock.

• Prevent metallic objects from coming into contact with the metal parts of the

connecting section. If this happens, a short circuit may occur and the unit may be
damaged.

• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit.
• The unit becomes warm during use. This is not a malfunction.