Playing CDs in Various Modes
Additional Information
Additional Information
Additional Information
25
GB
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
20 Hz to 20 kHz ±0.5 dB
Signal-to-noise ratio
More than 105 dB
Dynamic range
More than 93 dB
Harmonic distortion
Less than 0.0045 %
Channel separation
More than 97 dB
Outputs
ANALOG OUT
DIGITAL OUT
(OPTICAL)
General
Power requirements
Where purchased
Canada
Europe/Certain countries in
Asia
Other countries
Power consumption
12 W
Dimensions (approx.)
When the front cover is closed
(w/h/d)
430
×
200
×
480 mm (17
×
7 7/8
×
19 in.)
incl. projecting parts
Mass (approx.)
9.5 kg (21 lbs)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
CONTROL A1
cord
(supplied for Canadian models only) (1)
Remote commander (remote) (1)
R6 (size AA) batteries (2)
Design and specifications are subject to change without notice.
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
/
Check that the player is connected securely.
/
Make sure you operate the amplifier correctly.
The CD does not play.
/
There is no CD in a slot (“–NO DISC–”
appears).
Insert a CD.
/
Insert the CD with the label side facing right.
/
Clean the CD (see page 24).
/
Moisture has condensed inside the player. Open
the front cover and leave the player turned on
for about an hour (see page 24).
The remote does not function.
/
Remove obstacles in the path of the remote and
the player.
/
Point the remote at the remote sensor
g
on the
player.
/
Replace all the batteries in the remote with new
ones if they are weak.
/
Set the CD 1/2/3 switch on the remote
according to the position of the COMMAND
MODE selector displayed in the front panel
display (see page 5).
The player functions incorrectly.
/
The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.
Load impedance
Over 10 kilohms
Wave length: 660 nm
Maximum
output
level
2 V
(at 50 kilohms)
–18 dBm
Jack
type
Phono
jacks
Optical
output
connector
Power requirements
120 V AC, 60 Hz
220 V - 230 V AC, 50/60 Hz
110 V - 120 V or 220 V - 240 V
AC, adjustable, , 50/60 Hz