9
4-3. AGING MODE
This unit is equipped with an aging mode to check operations of the
mechanism deck.
• When faults occur:
Aging stops, and the state when aging stopped is displayed on the
fluorescent display tube.
• When no fault has occurred:
Aging is continued repeatedly.
Aging method 1
(When using the aging mode remote controller (J-2501-123-A)):
1. Press the POWER button and turn ON the power.
2. Set the disc on the tray.
3. Press the AGING START button of the aging remote controller.
4. Aging starts and the message shown in Fig. 1 is displayed on the
fluorescent display tube.
5. To end, press the POWER button.
Aging method 2 (When no aging mode remote controller):
1. Press the POWER button and turn ON the power.
2. Set the disc on the tray.
3. Press the
A
OPEN/CLOSE button,
x
button, and MUSIC
SCAN button at the same time. (If these buttons are not pressed
at the same time, nothing performs.)
4. Aging starts and the message shown in Fig. 1 is displayed on the
fluorescent display tube.
5. To end, press the POWER button.
Fig. 1 Message in Aging Mode
0
1
2
3
4
5
Load in
Access to TOC
Access to last track
Playback of last track
(3 seconds)
Access to first track
Playback of first track
(3 seconds)
AGING-0
AGING-1
AGING-2
Counter display
AGING-4
Counter display
AGING-6
ERROR-0
ERROR-1
ERROR-2
ERROR-3
ERROR-4
ERROR-5
ERROR-6
Code
No.
State
Display when
normal
Display when
abnormal
[ MAIN BOARD ] – Component Side –
CN302
JW003
(ADJ)
JW004
(AFADJ)
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
