9
Not this way
This way
Changing the output level
You can select the output level from the unit.
Normally the unit is used in the initial output
level; change the level if necessary.
1
Press
(SHUF/REP)
for two seconds.
2
Press
(SHUF/REP)
momentarily.
Initial setting
3
Press
or
repeatedly to
select the output level.
To decrease the output level
:
,
To increase the output level
:
,
4
Press
(SHUF/REP)
for two seconds.
Using on the wireless remote
1
Press
(SHUF)
for two seconds.
2
Press
(SHUF)
again momentarily.
3
Press
or
to select the
output level.
4
Press
(SHUF)
for two seconds.
Note
When you select level 4 or 5, the CD playback
sound may be distorted or you may hear some
noise. In such a case, select a lower output level on
the unit and turn down the overall volume on your
car audio.
Additional
Information
Precautions
• This unit cannot be used with a car audio
without FM tuner.
• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• Avoid installing the CD changer, wireless
remote, and wired remote in places:
— subject to temperature exceeding 55°C.
— subject to direct sunlight.
— near heat sources (such as heaters).
— exposed to rain or moisture.
— exposed to excessive dust or dirt.
— subject to excessive vibration.
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
Notes on compact discs
A dirty or defective disc may cause sound
drop-outs during CD playback. To enjoy
optimum sound, handle the disc as follows.
Handle the disc by its edge, and do not touch
the unlabelled surface.
Do not stick paper or tape on the discs.
